Whichever lock you go together with, be certain that it might loop round your lock-up level—a motorcycle rack, a safe fence—and via the triangular a part of your bike body, plus the spokes of your rear wheel. The picture above exhibits this technique. Don’t overlook to remove accessories earlier than you allow your bike.
Thread the lock via the free factors. Bikes are straightforward to disassemble, so be sure to thread the lock via the rear triangle within the body, as proven above, and that each wheels are secured to the lock-up level. It’s very straightforward for thieves to steal an unsecured entrance wheel, particularly if the wheel has a quick-release skewer. Some folks use two locks; you can even purchase separate cables to mix with any of the locks I discussed.
Keep your U-lock away from the bottom. Thieves wish to take a bottle jack, usually used for jacking up a automobile, and place it contained in the U. With sufficient pumping, the jack can break the lock open. If you get the U-lock away from the bottom, it makes it arduous for them to do that. You additionally need to get a U-lock that has as little additional area contained in the U as doable. The much less additional area, the much less room there may be for thieves to jam crowbars or different instruments via it.
Inspect your lock-up spot earlier than you resolve to park there. Thieves are identified to dislodge poles and signposts from the bottom and then place them again within the gap. All they should do is wait so that you can lock up your bike and depart, then they’ll raise the submit out of the opening to free your bike—no instruments or noise required.
Check out bike racks, too, particularly when you see tape wrapped round them. Bike thieves are identified to noticed via racks and then wrap the reduce part in tape to cover their work. When bike homeowners stroll away from a locked bike, the thief can yank the tape off, pry the severed bike rack aside sufficient to slip your lock out, and be on their means.